How to Make Your Wi-Fi Signal Stronger Than Usual Using Beer or Soda Cans -Health & Beauty Informations. This article, entitled How to Make Your Wi-Fi Signal Stronger Than Usual Using Beer or Soda Cans, we have prepared this article carefully for you so you can retrieve information therein. Hopefully you understand the contents of this article that we put under the category health, well, happy reading.

Title : How to Make Your Wi-Fi Signal Stronger Than Usual Using Beer or Soda Cans
link : How to Make Your Wi-Fi Signal Stronger Than Usual Using Beer or Soda Cans

How to Make Your Wi-Fi Signal Stronger Than Usual Using Beer or Soda Cans

Having a bad wi-fi connection can be very irritating. Poor load times, lost connections, and can put a strain on their time surfing the internet.

The reason WiFi signals are stronger near the router, and weakest in more distant parts of the house because the signal is affected both by the distance and obstacles, especially walls and appliances.

However, there are some ways to improve your Wi-Fi . And you can do this easily by using a can of soda or beer can be used from aluminum .

The video below shows us a simple trick that uses these cans to boost its WiFi reception of about 2 to about 4 bars on average, ranging between 3 and 5.

Everything you need for this DIY project are scissors or a knife and empty beer or soda cans -. 1 or 2, depending on the number of antennas that are in the router

Procedure:

1. Clean can

Virtually any substance found in cans such as soft drinks, beer, juice and more can create a sticky residue on the inside of the can. This can attract insects and make sticky your router. Before starting to cut apart from the can, rinse thoroughly with warm water and soap. Tin dried as thoroughly as possible.

2. Peel off the tongue

The record of the soda can really have no use for this project, so it is best to remove it. To remove the seal, simply fold the tab back and forth until it clicks.

3. Cut the bottom of the can

Grab a knife and carefully cut a straight line, horizontal around bottom of the can at the point where the sides of the slope can start creating the bottom.

4. Creating the

The basis for WiFi Extender will be the top of the can. To create the base, turn the can upside down and use your knife to make a horizontal cut cutting is similar to what has been done at the bottom of the can, but leave an inch or so of metal to keep everything in only one piece .

5. Cut the side of the can

Place the can so that the scrap piece of metal used to keep the base unit is opposite the location it intends to make a vertical incision in the can. Then open the can to create a similar way to a satellite dish.

6. Placement of the router Can until

Place the can on top of the antenna for Wi-Fi through the hole in the base. The use of tape or other adhesive easily removable, such as mastic adhesive, attach the can to your router. Adjust the can to maximize the signal.

Basically the can should splash out, creating something like a sail around the antenna of the router. The antenna serves as a mast and soda helps the function of the router.

This is not just a clever use of a beer / soda can trick technology ultra cheap, but it also means less waste time with cardboard and aluminum foil as required by other methods of hacking.

(Source: MindblowingVideos )

Thanks for Reading How to Make Your Wi-Fi Signal Stronger Than Usual Using Beer or Soda Cans

Thank you for reading this How to Make Your Wi-Fi Signal Stronger Than Usual Using Beer or Soda Cans, hopefully can give benefits to all of you. well, see you in posting other articles.

You are now reading the article How to Make Your Wi-Fi Signal Stronger Than Usual Using Beer or Soda Cans Url Address https://healthnbeautyarticles.blogspot.com/2016/04/how-to-make-your-wi-fi-signal-stronger.html